- 16 Osier View, Lavenham, Sudbury, Suffolk
- hello@akita.ac
- 0330 043 7537
- +1 - (402) 782-2221
A single room is normally one day, start to finish. Here’s exactly what that looks like, so nothing on the day is a surprise.
Before anything is drilled, we walk the job with you — where the indoor unit sits, where the condenser goes outside, and how the pipework runs between them. Nothing starts until you are happy.
One core through the wall, insulated refrigerant pipework and cabling run to the condenser position, and a condensate route that drains properly rather than onto your wall.
Indoor unit onto its bracket, condenser onto feet or brackets outside, flares made and torqued to spec, electrical connections made.
The system is pressure tested for leaks, then vacuumed down to pull out moisture and air. Skipping this is the most common shortcut in the trade and the most common cause of early failure.
Charge released, running temperatures and pressures checked, performance logged in both heating and cooling.
Cores sealed, trunking finished, site cleared. We show you the controls, the filters and how to clean them, and leave you the paperwork.
Five minutes, no visit needed, and the quote holds for 90 days.
© 2025 Created with Royal Elementor Addons
